|
 Delta
24" Industrial Planer
Printable Version & Specifications
Owner's Manual - Not Available
Parts List
Model 22-610 New
Model 22-610R
Factory Reconditioned
Click Here For Pricing
Delta Industrial Model 22-610 RC-63D 24 3/4" X 9 3/8" Planer with a
10HP, 200-220/440V (wired 220V), 60 Hz., three-phase motor with 24-volt LVC
magnetic starter and automatic reset overload; standard 4-knife cutterhead; set
of four case hardened, high-speed steel knives and knife setting gage.
THE DELTA DIFFERENCE
- Power-driven table raises and lowers simply and quickly. Fine adjustments
are made using the convenient hand wheel.
- Lumber gauge enables operator to measure stock thickness quickly.
- Rear pressure bar maintains even force on planed stock; outfeed roll helps
maintain positive feeding under all conditions.
- Efficient, fully accessible drive system makes it easy to change feed
speed by simply move V-belt from one pulley step to the other.
- Standard equipment dust chute has a 6" opening for easy connection to a
central dust collection system.
- Outfeed roll is driven through feed gear box and supplies power to the
infeed roll and table raising and lowering gear box mechanism. Heavy duty
chains and sprockets are used throughout the system.
- Complete cutterhead and feed group are modulary mounted to the machine
frame, including seperate bearing blocks for cutterhead. This allows the
entire cutterhead to be removed without disturbing feed system settings.
System also includes twelve 2" wide sectional chip breakers for full width,
even pressure on wide, tapered stock. Full width anti-kickbacks provide added
safety.
- Spacious table raises and lowers on four precision, self-locking screws.
Solid steel gibs keep table in perfect alignment regardless of thickness of
cut. Dust-proof rubber boots protect screws from abrasive dust and moisture.
- Large 24" X 35 1/2" precision-ground table is equipped with two adjustable
bed rolls located directly below feed rolls for smooth, positive feeding. Bed
roll height can be quickly adjusted from the front of the machine to suit
variations in planing conditions.
|
