-
29 spindle construction boring machine
-
Quick change chucks are standard (10)
-
Spindle mounted in gear head with two
sealed ball bearings
-
Hardened steel gear pressed onto spindle
-
pindles are 32mm on center
-
29 spindles are driven by two 1.5hp
motors
-
Head tilts from 0 – 90˚ (vertical to
horizontal) pneumatically
-
Machine is equipped with stop at 45˚ For
head tilt
-
Pneumatic movement of boring head via
foot pedal
-
Three pneumatic hold downs that
automatically activate when machine is cycled
-
Grease fitting on boring head
-
Equipped with 79” back fence
-
Equipped with two lateral fences
-
One 39” fence extension
-
Four flip stops
-
Mirror imaging device (to set both
lateral fences)
-
One mechanical digital read-out for drill
bit position
-
Special plate for drilling a 45˚ miter
-
One index pin for line boring
-
Tool set included
